1 NewSketch 1212 for R13(DOS Version) 02/17/1995 The steps of installation is following: 1.Insert the NewSketch Utilities diskette into B drive a. Type "dgadi" to install tablet driver b. Type "adiinst" to install ADI driver (choose Real mode), then driver is installed completely. 2.Enter in Autocad a. Type "config" b.Current AutoCad Configuration [ Enter ] c.Configuration menu, choose [4] configure digitizer d.Do you want to select a different one [N], Press [Y,] if you want to change driver e.Available digitizer: ADI DRIVER : 1.ADI digitizer (Real mode) [2] 2.Hexadcial interrupt code < INT 0xxh> <79>: [ Enter ] 3.Configure Menu: [0] Exit to drawing editor if you don't want to change configuration any more 4.Keep configuration changed :[Y] 5.return to AutoCad R13. MM SERIES : 1.Summagraphics MM Series [10]-- for 4-button puck 2.Supported mode:[6] or [3]-- model 1201 III 1,4 button or mode 1201 II 1, 4 button 3.Two different modes of operation:[2]--default 4.Digitizer type of cursor: [4 button] 5.Communication Adapter: [COM1] or [COM2] 6.Configure Menu: [0] Exit to drawing editor if you don't need to change configuration any more 7.Keep configuration changed :[Y] 8.return to AutoCad R13. While using stylus, the steps of installation are the same.  wtpmiea]YvpޒWW KFW4 7FWJXX &Q DXxk  Arial